vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-008 Pedal Position Sensor Circuit > < C-006 5V Circuit 2

Astra H

C-007 - 5V Circuit 3

Test

Work Order Description

Nominal Value
T001

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Diesel Particulate Filter
Yes: No:
T002

Check: Component
  • Ignition OFF
  • Disconnect wiring harness connector from:
    B175 Sensor - Pressure, Exhaust Gas
  • Ignition ON
  • Trouble Code Update

Is the diagnostic trouble code P0697 with status PRESENT stored?
Yes: No:
T003

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Astra-H, Air Conditioning (not ECC)
Astra-H, Electronic Climate Control ECC
Astra-H, Automatic Climate Control SAC
Yes: No:
T004

Check: Component
  • Ignition OFF
  • Disconnect wiring harness connector from:
    B18 Sensor - Pressure, Air Conditioning
  • Ignition ON
  • Trouble Code Update

Is the diagnostic trouble code P0697 with status PRESENT stored?
Yes: No:
T005

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Diesel Particulate Filter
Yes: No:
T006

Check: Short to Voltage of Voltage Supply Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    A84 Control Unit - Engine
    (Wiring Harness Connector XC53 )
  • Ignition ON
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 44 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T007

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Measure resistance between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 44 (XC53)
    &
    Ground

greater than 500 kOhm
Resistance Measurement Current Value: kOhm
Yes: No:
T008

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Astra-H, Air Conditioning (not ECC)
Astra-H, Electronic Climate Control ECC
Astra-H, Automatic Climate Control SAC
Yes: No:
T009

Check: Short to Voltage of Voltage Supply Circuit
  • Disconnect wiring harness connector from:
    A84 Control Unit - Engine
    (Wiring Harness Connector XC53 )
  • Ignition ON
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 22 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T010

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Measure resistance between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 22 (XC53)
    &
    Ground

greater than 500 kOhm
Resistance Measurement Current Value: kOhm
Yes: No:
T011

Check: Short to Voltage of Ground Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    A84 Control Unit - Engine
    (Wiring Harness Connector XC53 )
  • Ignition ON
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 12 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T012

Check: Short to Voltage of Signal Circuit
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 13 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T013

Check: Short to Voltage of Signal Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    A84 Control Unit - Engine
    (Wiring Harness Connector XC53 )
  • Ignition ON
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 37 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:
T014

Check: Short to Voltage of Ground Circuit
  • Measure voltage between the following terminals:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 36 (XC53)
    &
    Ground

less than 0.3 V
Voltage Measurement Current Value: V
Yes: No:


Result

Cause Of Fault
E001 Result: Defective Component
  • Defective component:
    A84 Control Unit - Engine

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E002 Result: Short to Ground
  • Short circuit to ground between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 22 (XC53)
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 10 (XE3)
    or
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 37 (XE1)
    &
    B18 Sensor - Pressure, Air Conditioning
    Wiring harness connector (wiring harness side) terminal 2

or

  • Defective component:
    X125 Underhood Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E003 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 22 (XC53)
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 10 (XE3)
    or
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 37 (XE1)
    &
    B18 Sensor - Pressure, Air Conditioning
    Wiring harness connector (wiring harness side) terminal 2

or

  • Defective component:
    X125 Underhood Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E004 Result: Short to Ground
  • Short circuit to ground between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 44 (XC53)
    &
    B175 Sensor - Pressure, Exhaust Gas
    Wiring harness connector (wiring harness side) terminal 1
E005 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 44 (XC53)
    &
    B175 Sensor - Pressure, Exhaust Gas
    Wiring harness connector (wiring harness side) terminal 1
E006 Result: Defective Component
  • Defective component:
    B18 Sensor - Pressure, Air Conditioning
E007 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 13 (XC53)
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 8 (XE3)
    or
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 30 (XE1)
    &
    B18 Sensor - Pressure, Air Conditioning
    Wiring harness connector (wiring harness side) terminal 3

or

  • Defective component:
    X125 Underhood Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E008 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 12 (XC53)
    &
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 7 (XE3)
    or
    X125 Underhood Electronic Module
    Wiring harness connector (wiring harness side) terminal 10 (XE1)
    &
    B18 Sensor - Pressure, Air Conditioning
    Wiring harness connector (wiring harness side) terminal 1

or

  • Defective component:
    X125 Underhood Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E009 Result: Defective Component
  • Defective component:
    B175 Sensor - Pressure, Exhaust Gas
E010 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 36 (XC53)
    &
    B175 Sensor - Pressure, Exhaust Gas
    Wiring harness connector (wiring harness side) terminal 3
E011 Result: Short to Voltage
  • Short circuit to voltage between:
    A84 Control Unit - Engine
    Wiring harness connector (wiring harness side) terminal 37 (XC53)
    &
    B175 Sensor - Pressure, Exhaust Gas
    Wiring harness connector (wiring harness side) terminal 2





C-008 Pedal Position Sensor Circuit > < C-006 5V Circuit 2