|
Heat Protection Sleeve, Remove and Install
 Remove
Important: After removal, place
cylinder head on wooden blocks as otherwise the glow plugs and
valves may be damaged.
|
| 1. |
Remove cylinder head
|
Important: KM-6049 must be positioned vertically on the guide
(2) of the heat protection sleeve to avoid damage to the cylinder
head
|
| 2. |
Knock heat protection sleeves with KM-6049 (1) out of cylinder head from below
|
|
|
Install
| 4. |
Insert heat protection sleeve (2) into cylinder head from
above
|
| 5. |
Knock heat protection sleeves into cylinder head with KM-6093 (3)
|
|
|
|
