Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Oil Pressure
|
- Ignition OFF
- Connect oil-pressure manometer KM-498-B with adapter KM-892
- Parking brake applied
- Brake pedal actuated
- Engine running at idle speed, operating temperature
- Selector lever in position D
- Read oil pressure and notice it down in the form sheet for automatic transmission diagnostics
Note:
The oil pressure is measured with the manometer KM-498-B .
-
Refer to Service Manual
000601974
|
3600 hPa ( 3.6 bar ) to 5200 hPa ( 5.2 bar )
|
|
T002
|
Check: Oil Pressure
|
- Parking brake applied
- Brake pedal actuated
- Engine running at idle speed, operating temperature
- Selector lever in position R
- Read oil pressure and notice it down in the form sheet for automatic transmission diagnostics
|
5900 hPa ( 5.9 bar ) to 8200 hPa ( 8.2 bar )
|
|
T003
|
Check: Stall Speed
|
Important:
The test should last for a maximum of 5 s , because the automatic transmission oil gets extremely hot. Check the oil temperature with the diagnostic tester before running the tests. If necessary, let the automatic transmission oil cool down first.
- Parking brake applied
- Brake pedal fully depressed
- Engine running at idle speed, operating temperature
- Automatic transmission oil temperature between 60 °C (140 °F) and 85 °C (185 °F)
- Selector lever in position D
- Accelerator pedal actuated to full load stop
- Record stall speed in the form sheet for automatic transmission diagnostics.
Concerned Terminals:
-
|
1800 rpm to 2400 rpm
|
|
T004
|
Check: Stall Speed
|
Important:
The test should last for a maximum of 5 s , because the automatic transmission oil gets extremely hot. Check the oil temperature with the diagnostic tester before running the tests. If necessary, let the automatic transmission oil cool down first.
- Parking brake applied
- Brake pedal fully depressed
- Engine running at idle speed, operating temperature
- Automatic transmission oil temperature between 60 °C (140 °F) and 85 °C (185 °F)
- Selector lever in position R
- Accelerator pedal actuated to full load stop
- Record stall speed in the form sheet for automatic transmission diagnostics.
Concerned Terminals:
-
|
1800 rpm to 2400 rpm
|
|
T005
|
Check: Oil Pressure at Stall Speed
|
Important:
The test should last for a maximum of 5 s , because the automatic transmission oil gets extremely hot. Check the oil temperature with the diagnostic tester before running the tests. If necessary, let the automatic transmission oil cool down first.
- Parking brake applied
- Brake pedal fully depressed
- Engine running at idle speed, operating temperature
- Automatic transmission oil temperature between 60 °C (140 °F) and 85 °C (185 °F)
- Selector lever in position D
- Accelerator pedal actuated to full load stop
- Read oil pressure and notice it down in the form sheet for automatic transmission diagnostics
|
11200 hPa ( 11.2 bar ) to 12700 hPa ( 12.7 bar )
|
|
T006
|
Check: Oil Pressure at Stall Speed
|
Important:
The test should last for a maximum of 5 s , because the automatic transmission oil gets extremely hot. Check the oil temperature with the diagnostic tester before running the tests. If necessary, let the automatic transmission oil cool down first.
- Parking brake applied
- Brake pedal fully depressed
- Engine running at idle speed, operating temperature
- Automatic transmission oil temperature between 60 °C (140 °F) and 85 °C (185 °F)
- Selector lever in position R
- Accelerator pedal actuated to full load stop
- Read oil pressure and notice it down in the form sheet for automatic transmission diagnostics
|
15400 hPa ( 15.4 bar ) to 18000 hPa ( 18.0 bar )
|
|