|
Test
|
Work Order Description
|
Nominal Value
|
|
T001
|
Check: Vehicle Configuration
|
|
Is the following information correct for the actual vehicle?
Z 18 XE
|
|
|
|
|
T002
|
Check: Other system
|
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System on the diagnostic tester:
Simtec 71.6, Z 18 XE
- Check the following data list parameters:
Perform the following troubleshooting:
After successful test/fault repair proceed to the next test step
|
|
|
|
|
T003
|
Check: Vehicle Configuration
|
|
Is the following information correct for the actual vehicle?
Z 18 XER
|
|
|
|
|
T004
|
Check: Other system
|
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System:
Simtec 75, Z 18 XER
- Check the following data list parameters:
Perform the following troubleshooting:
After successful test/fault repair proceed to the next test step
|
|
|
|
|
T005
|
Invalid / not supported vehicle configuration
|
- The selected Checking Procedure is not valid for this vehicle configuration.
|
|
|
|
