Intermediate Drive Gear (Driven), Replace
(AF17)
Remove
2. |
Remove multi-plate clutch assembly C1
|
3. |
Remove multi-plate clutch assembly C0 and C3
|
4. |
Remove rear ring gear assembly with freewheel F0
|
5. |
Remove front ring gear assembly with freewheel F1 and planetary
carrier
|
7. |
Remove assembly, drive shaft with multi-plate clutch C2
|
9. |
Remove intermediate drive gear (3)
• |
Detach retaining ring (2) with KM-396
(1)
|
• |
Turn transmission by 90 ° and lock
|
• |
If necessary, release intermediate drive gear from the opposite
side of the housing with a rubber mallet
|
|
|
|
Install
10. |
Install intermediate drive gear (1)
• |
drive in carefully with a rubber hammer as far as the stop
|
• |
Turn transmission by 90 ° and lock
|
• |
Install retaining ring (3) with KM-396 (2)
|
|
|
|
11. |
Install brake band B1
|
12. |
Install assembly, drive shaft with multi-plate clutch C2
|
14. |
Install front ring gear assembly with freewheel F1 and
planetary carrier
|
15. |
Install rear ring gear assembly with freewheel F0
|
16. |
Install multi-plate clutch assembly C0 and C3
|
17. |
Install multi-plate clutch assembly C1
|
|