Vauxhall Workshop Service and Repair Manuals

Selector Lever Position Switch, Replace (Z18XER/A18XER - AF17)

  Remove

1.	Remove left engine damping block

2.   Detach selector actuation cable (2) from actuation lever. 3.   Remove wiring harness plug (1) from selector lever position switch •   Release wiring harness plug (arrow) and disconnect

4.   Detach actuation lever (2) from selector lever shaft •   Unscrew nut (1)

5.   Unscrew 2x bolt (1)

6.   Unscrew nut (1) •   Bend open retaining plate (2) 7.   Release selector lever position switch from selector lever shaft and transmission

  Install

8.   Attach selector lever position switch to selector lever shaft and transmission •   Attach new retaining plate (2) •   Tighten nut (1) 8 Nm – Secure nut with retaining plate

9.   Screw in 2x bolt (1) Note:   Do not tighten bolts yet

10.   Attach actuating lever (2) to selector lever shaft •   Tighten nut (1) 16 Nm

11.	Adjust selector lever position switch

13.   Attach selector actuator cable (2) to actuation lever 14.   Attach wiring harness plug (1) to selector lever position switch •   Attach wiring harness plug and lock (arrow)

15.	Adjust selector actuation cable

16.	Fit left engine damping block