Test
|
Work Order Description
|
Nominal Value
|
T001
|
Tester Display Bleed Clutch Hydraulic
|
- Ignition ON
- Engine OFF
- Vehicle stationary
- Parking brake applied
- Selector lever in position N
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
|
Test okay?
|
Concerned Terminals: -
|
|
T002
|
Tester Display Learn Gearbox Parameters
|
- Vehicle jacked-up so that the wheels can turn freely
- Ignition ON
- Engine OFF
- Selector lever in position N
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
Note:
During the check, the battery must be in good condition and adequately charged (Battery voltage greater than 11 V ).
|
Test okay?
|
Concerned Terminals: 108, 109, 115, 116, 118, 121 (XC14)
|
|
T003
|
Tester Display Touch Point Adaption
|
- Ignition ON
- Engine OFF
- Vehicle stationary
- Parking brake applied
- Brake pedal actuated
- Selector lever in position N
- Accelerator pedal not actuated
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
|
Test okay?
|
Concerned Terminals: -
|
|
T004
|
Tester Display Read ECU Identification
|
- Ignition ON
- Engine OFF
- Vehicle stationary
- Press corresponding key in the system main menu to call up Additional Functions, select the desired test and confirm with ENTER . Follow the instructions in the diagnostic tester display.
|
Test okay?
|
Concerned Terminals: -
|
|