Remove and install bearing for main and drive
shaft in transmission housing MY 2008 onward (F17+/F17+ MTA)
Note: Transmission
remains installed.
Remove
|
1. |
Remove gearbox cover (1)
Note: For F17+
transmission.
Remove gearshift module (2)
Note: For F17+ MTA
transmission.
|
2. |
Remove reversing lamps switch (3).
• |
Disconnect wiring harness plug, reversing lamp switch (4)
|
• |
Unscrew reversing lamp switch
|
|
|
|
3. |
Attach KM-6001-B to front axle
body
• |
Release 2x bolt (arrows) for adjustment rails on KM-6001-B (1)
|
• |
Insert KM-6001-B as shown
Note: 2x journals (2)
and (5) must sit flush in the guide holes of the front axle
body.
|
• |
Tighten 2x bolt for adjustment rails
|
• |
Twist up front support bearing (4)
– |
as far as the stop on the guide pin of the front engine damping
block
Note: The guide pins
must sit in the support bearings with no play.
|
|
• |
Twist up rear support bearing (3)
– |
as far as the stop on the guide pin of the rear engine damping
block bracket
Note: The guide pins
must sit in the support bearings with no play.
|
|
|
|
4. |
Remove front axle body
|
|
5. |
Remove end shield (1) cover
|
|
|
8. |
Remove needle bearing 3) for drive shaft
• |
Remove needle bearing with from transmission housing KM-556-A (1) and MKM-599 (2)
|
|
9. |
Remove roller bearing (4) for main shaft
• |
Remove roller bearing from transmission housing with KM-556-A (6) and KM-556-2 (5)
|
|
|
Install
|
10. |
Fit roller bearing (3) for main shaft
• |
Install roller bearing flush in transmission housing with DT-49114 (5) and KM-523-1 (4)
|
|
11. |
Fit needle bearing (2) for drive shaft
Note: Needle bearing
side with writing points to transmission.
• |
Install needle bearing flush in transmission housing with KM-454-2 (6) and KM-454-4 (1)
|
|
|
|
13. |
Install end shield (2)
|
14. |
Attach end shield cover (1)
|
|
15. |
Install front axle body
|
16. |
Detach KM-6001-B from front axle
body
|
|
17. |
Fit reversing lamp switch (3)
• |
Tighten reversing lamp switch 20
Nm
|
• |
Connect wiring harness plug (4) to reversing lamp switch
|
|
18. |
Install gearbox cover (1)
Note: For F17+
transmission.
Install gearshift module (2)
Note: For F17+ MTA
transmission.
|
|
|