Drive shaft and/or drive shaft ball bearing,
replace (F13+/F13+ MTA)
Note: Transmission
remains installed.
Overview drive shaft
Remove
2. |
Remove drive shaft
Note: In case of damage
to the teeth of the toothed wheel block, always check the main
shaft of the corresponding gear wheel and replace it if
necessary.
|
|
3. |
Remove drive shaft bearing (1) from end plate
• |
Press bearing out with KM-500-5
|
|
4. |
Remove main shaft bearing (2) from end plate
• |
Press bearing out with KM-500-5
|
|
|
5. |
Clean all parts and sealing surfaces
|
6. |
Check all parts for damage
Note: Replace damaged
parts.
|
Install
7. |
Oil turning parts with transmission oil on their bearing,
running, seating or press surfaces
|
|
8. |
Install drive shaft bearing (1) in end plate
• |
Press bearing in with KM-519
|
|
9. |
Install main shaft bearing (2) in end plate
• |
Press bearing in with KM-373-1
|
|
|
|