Transmission Relay Point, Remove and Install
(F13/F13+/F17+)
Remove
1. |
Draw manual gearshift lever into 4th gear position
|
2. |
Remove battery support
|
3. |
Release gearshift rod
• |
Release bolt (1) for relay point clamp
Note: Do not remove
bolt.
|
|
|
|
4. |
Detach transmission rocker arm from relay point bracket
• |
Detach 2x retaining clamp (1) and (2) from transmission rocker
arm
|
|
5. |
Detach gearshift rod from universal joint
• |
Press in retaining spring (arrow) of the hollow pin (3)
|
• |
Detach hollow pin with KM-569-A
|
|
|
|
Install
6. |
Attach transmission rocker arm to relay point bracket
• |
Attach 2x retaining clamp (1) and (2) to transmission rocker
arm
Note: Use new retaining
clamps.
|
|
7. |
Attach gearshift rod to universal joint
• |
Attach hollow pin
Note: Use new hollow
pin
Retaining spring (arrow) of hollow pin (3) must engage
|
|
|
|
8. |
Attach gearshift rod to relay point
Note: Do not tighten
bolt (1) yet
|
|
|
9. |
Install battery support
|
10. |
Transmission Shift Linkage, Adjust
|
11. |
Program volatile memories
|
|