Transmission Shift Linkage, Adjust (F 17+)
Remove
1. |
Remove battery support
|
2. |
Release gearshift rod
• |
Release bolt (1) for relay point clamp
Note: Do not remove
bolt.
|
|
|
|
|
3. |
Detach cover of manual shift lever (1)
• |
Unclip cover of manual shift lever at the front (arrows) from
central console
|
• |
Prop up cover of manual shift lever with cover frame
|
|
|
4. |
Lock manual shift lever in adjustment position
• |
Push manual shift lever to the left
|
• |
Lock manual shift lever and shift lever housing (arrows) with
KM-527-A (1)
|
|
|
|
5. |
Lock gearshift lever shaft in the gearbox cover
• |
Turn gearshift rod anti-clockwise
|
• |
Engage locking pin (1) in the adjusting bore in the gearbox
cover (arrow)
|
|
|
|
Install
6. |
Fix gearshift rod
Note: Do not change
position of gearshift rod.
• |
Tighten bolt (1) 12 Nm +
(180...225)°
|
|
|
|
7. |
Release manual shift lever lock
|
|
|
|
8. |
Attach cover of manual shift lever (1)
• |
Insert cover of manual gearshift lever at the rear in the
central console
|
• |
Clip cover of manual gearshift lever into the central console
at the front (arrows)
|
|
|
9. |
Release locking pin in the gearbox cover
Note: Locking pin in
adjusting bore hole releases automatically when first shifted in
"R" direction – if necessary release locking pin by hand.
|
10. |
Check ease of gear shifting
|
11. |
Install battery support
|
12. |
Program volatile memories
|
|