Note: Do not allow
the electro-hydraulic supply unit to run dry.
Drained fluid must not be re-used. The hydraulic system is filled
with special fluid
Use a funnel with a flexible pipe to fill the hydraulic system.
The fluid reservoir is integrated in the electro-hydraulic supply
unit and is located:
- on right-hand side of engine compartment between engine and
bulkhead (vehicles with LHD), or
- on left-hand side of engine compartment between transmission
and bulkhead (vehicles with RHD).
Fill and bleed the hydraulic system at room temperature. Leave
hydraulic systems at operating temperature to cool down to room
temperature.
To check the fluid level, the closure cap (1) of the fluid
reservoir is locked, then removed again and the level is read off
on the dipstick (2).
|