Replace Open and Start control unit - L48
Note: When replacing
the control unit, before removing the control unit carry out a
Reset with TECH 2.
Remove
|
3. |
Disconnect wiring harness plug for rear electronics module
(REC)
• |
Disconnect 6x wiring harness plug (1) and (3)
|
|
4. |
Release rear electronics module (REC)
|
5. |
Remove rear electronics module (REC)
Note: Only for vehicles
with park pilot control unit.
Note: Please pay
attention to this when replacing the rear electronics module
(REC)
The rear electronics module (REC) contains the maximum number of
relays and fuses. The rear electronics module will contain surplus
relays and fuses.
• |
Unclip park pilot control unit (2)
|
|
|
6. |
Detach Open and Start control unit
• |
Unclip Open and Start control unit (arrow)
|
|
|
|
Install
7. |
Attach Open and Start control unit
• |
Clip control unit into Rear Electronic Module (REC)
|
|
8. |
Insert rear electronics module (REC)
Note: Only for vehicles
with park pilot control unit.
• |
Clip in park pilot control unit (PAS)
|
|
9. |
Attach rear electronics module (REC)
|
10. |
Connect wiring harness plug for rear electronics module
(REC)
• |
Connect 6x wiring harness plug
|
|
13. |
Program volatile memories
Note: When replacing
the control unit, program control unit with TECH 2.
|
|