Test
|
Work Order Description
|
Nominal Value
|
T001
|
Check: Short to Voltage/Ground/Interruption of Signal Circuit
|
- Ignition OFF
- Disconnect wiring harness connector from:
B51 Sensor - Brake Lining, Front, Left
- Ignition ON
- Measure voltage between the following terminals:
B51 Sensor - Brake Lining, Front, Left Wiring harness connector (wiring harness side) terminal 2 & Ground
|
7 ... 8 V
|
|
|
T002
|
Check: Short to Voltage of Signal Circuit
|
- Ignition OFF
- Connect fused jumper wire to:
B51 Sensor - Brake Lining, Front, Left Wiring harness connector (wiring harness side) terminal 2 & Ground
- Ignition ON
Data List
- Select the following Functional System on the diagnostic tester:
Instrument
- Check the following data list parameters:
Brake Pad Sensor Left Front
Note:
This data list parameter is in the data list 4 .
|
Inactive
|
|
|
T003
|
Check: Circuit Interruption of Ground Circuit
|
- Ignition OFF
- Measure resistance between the following terminals:
B51 Sensor - Brake Lining, Front, Left Wiring harness connector (wiring harness side) terminal 3 & Ground
|
less than 5 Ohm
|
|
|
T004
|
Check: Component
|
Data List
- Select the following Functional System on the diagnostic tester:
Instrument
- Check the following data list parameters:
Brake Pad Sensor Left Front
Note:
This data list parameter is in the data list 4 .
|
Active
|
|
|
T005
|
Check: Short to Ground/Interruption of Signal Circuit
|
- Ignition OFF
- Disconnect wiring harness connector from:
X125 Underhood Electronic Module
- Measure resistance between the following terminals:
X125 Underhood Electronic Module Wiring harness connector (wiring harness side) terminal 27 (XE2) & B51 Sensor - Brake Lining, Front, Left Wiring harness connector (wiring harness side) terminal 2
|
less than 5 Ohm
|
|
|