|
Brief description of touch-in painting (three-coat
paint applications)
Brief Description of Touching-up
Clean and sand damaged area. Apply putty, if necessary. Clean,
degrease, apply filler to damaged area. Sand filler.
Give a matt finish to the damaged zone - including adjoining
part - using sanding paste and sanding/matting pad fine.
Mix basefix with 200% universal thinner.
1st coat: apply mixed 1st base paint to cover damaged part.
Note drying time. Do not blow-dry surfaces. Rub off surface
using tack cloth.
2nd coat: apply mixed 1st base paint fading out. Allow to
dry.
1st coat: apply mixed 2nd effect layer paint to the damaged
part. Apply paint fading out past the perimeter zones of the first
paint application (100% material use). Allow to dry.
2nd coat: apply mixed 2nd effect layer paint (80% material use).
Allow to dry.
Rub down surface with tack cloth. Feather surface. Note spray
pressure. Rub down surface with tack cloth.
Apply 1 feathering coat of mixed clear coat over complete part.
Observe drying time.
Apply one more coat of clear coat. Then allow to set and
dry.
Example: Fault in front wing, outside. Touching-up the part with
base and clear coat.
|
Paint system
|
|
1
|
Damaged part
|
|
2
|
Apply basefix to repaired part/surface
|
|
3
|
Apply base paint (to finish-sanded filler)
|
|
4
|
Apply effect layer paint
|
|
5
|
Fog zone 1/3
|
|
6
|
Apply clear coat (complete)
|
|
|
|
