|
Operational procedure
|
Paint stage
|
Products
|
Notes
|
| |
I
|
II
|
III
|
|
|
|
Clean
|
x
|
x
|
x
|
Antistatic / silicone remover
|
Remove inorganic agents.
Spray on using pump atomiser and dry well using
highly absorbent cloth.
|
|
Sand
|
x
|
x
|
x
|
Wet or dry
|
Sand down fault site with grain P600. Give a matt finish to
remaining surface using sanding/matting pad fine, blend prep.
|
|
Clean
|
x
|
x
|
x
|
Aqueous degreaser
|
Spray on using pump atomiser and dry well using highly absorbent
cloth.
|
|
Putty application
|
x
|
–
|
x
|
Polyester universal putty
|
Apply to bare metal areas.
|
|
Sand
|
x
|
–
|
x
|
Dry
|
Only sand polyester universal putty when dry.
|
|
Clean
|
x
|
x
|
x
|
Aqueous degreaser
|
Spray on using pump atomiser and dry well using highly absorbent
cloth.
|
|
Prime or
|
x
|
–
|
x
|
2C EP primer-surfacer or 2C HS Multi-filler
|
Apply two individual feathering coats with 5 min intermediate
drying time to welded joints and areas subject to stone
chipping.
|
|
Apply filler
|
x
|
–
|
x
|
2-C multicolour filler
2-C-HS Multi-filler
|
Colour can be mixed, using mixing recipes, to achieve car
colour.
One to three feathering individual coats with 5
minutes drying time between coats.
Dry 30 minutes at 20°C.
|
|
Sand
|
x
|
–
|
x
|
Dry
|
Use eccentric P400 to P500
|
| |
|
|
|
|
|
|
Clean
|
x
|
–
|
x
|
Aqueous degreaser
|
Spray on using pump atomiser and dry well using highly absorbent
cloth.
|
|
Spray base paint
|
x
|
x
|
x
|
Water base coat
|
Apply two feathering single coats wet on wet.
Allow to flash dry until surface has dried matt.
Feather once at reduced pressure, if required.
Setting time prior to the clear coat application
15 minutes.
|
|
Spray clear coat
|
x
|
x
|
x
|
As required.
2-C HS clear coat
VOC clear coat
Water base clear coat
|
Pre-spray one layer. Setting time 3 to 5 minutes. Final spraying
with one more layer. Setting time 8 minutes prior to oven
drying.
|
