Trunk/Liftgate Ajar Indicator Malfunction
Diagnostic Instructions
Diagnostic Fault Information
Circuit
|
Short to Ground
|
Open/High Resistance
|
Short to Voltage
|
Signal Performance
|
Rear Compartment Lid Ajar Switch Signal
|
2
|
2
|
2
|
-
|
Rear Compartment Lid Latch Ground
|
1
|
1
|
--
|
--
|
1. Boot Release Malfunction
2. Boot Ajar Indicator Malfunction
|
Circuit/System Description
The body control module (BCM) receives a discrete input from the
rear compartment lid ajar switch signal circuit. When the rear
compartment lid release actuator releases the rear compartment lid,
the rear compartment lid ajar switch, which is internal to the rear
compartment lid release actuator, is supplied with ground which
causes the boot ajar switch signal circuit to be pulled low. The
BCM interprets this and communicates via serial data with the
instrument panel cluster. When the boot is open/ajar and the
vehicle is in any gear other than Park, the driver information
centre will display BOOT OPEN. If the boot is still open and the
vehicle speed is greater than 5 km/h (3 MPH) a chime will
sound.
Reference Information
Schematic Reference
Release Systems Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Luggage Compartment Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References
Circuit/System Verification
Ignition ON, observe the scan tool Rear Closure Ajar Switch
parameter while opening and closing the trunk. The parameter should
change between Inactive and Active.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the
M30 Tailgate Latch.
- Test for less than 5 Ω between the ground circuit
terminal 1 and ground.
⇒ |
If greater than the specified value, test the
ground circuit for an open/high resistance. |
- Ignition ON, verify the scan tool Rear Closure Ajar
Switch parameter is Inactive.
⇒ |
If not the specified value, test the signal
circuit terminal 2 for a short to ground. If the circuit tests
normal, replace the K9 Body Control Module. |
- Install a 3 A fused jumper wire between the
signal circuit terminal 2 and ground. Verify the scan tool
Rear Closure Ajar Switch parameter is Active.
⇒ |
If not the specified value, test the signal
circuit terminal 2 for a short to voltage or an open/high
resistance. If the circuit tests normal, replace the K9 Body
Control Module. |
- If all circuits test normal, test or replace the
M30 Tailgate Latch.
Component Testing
Static Test
- Ignition OFF, disconnect the harness connector at the
M30 Tailgate Latch.
- Test for infinite resistance between the signal
terminal 2 and the ground terminal 1 with the boot in the
closed position.
⇒ |
If not the specified value, replace the
M30 Tailgate Latch. |
- Test for less than 5 Ω between the signal
terminal 2 and the ground terminal 1 with the boot in the
open position.
⇒ |
If greater than the specified range, replace the
M30 Tailgate Latch. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
|