DTC P2428
Diagnostic Instructions
DTC Descriptor
DTC P2428 00: Exhaust Gas Temperature Sensor 1
- High Temperature |
Circuit/System Description
The exhaust gas temperature sensor is a variable resistor that
measures the temperature of the exhaust gas. The exhaust gas
temperature sensor is located in the exhaust gas particulate
filter. The engine control module (ECM) supplies 5 V to the exhaust
gas temperature signal circuit and supplies a ground to the low
reference circuit. The exhaust gas temperature sensor temperature
information is used by the ECM during the exhaust gas particulate
filter cleaning process.
The following table illustrates the difference between
temperature, resistance, and voltage:
Exhaust Gas Temperature
|
Exhaust Gas Temperature Resistance
|
Exhaust Gas Temperature Signal Voltage
|
Cold
|
High
|
High
|
Warm
|
Low
|
Low
|
|
|
Conditions for Running the DTC
• |
The engine is running at
operating temperature. |
• |
The DTCs run continuously when
the above condition is met. |
Conditions for Setting the DTC
Diesel particle filter regeneration is OFF.
Action Taken When the DTC Sets
DTC P2428 is a Type A DTC.
Conditions for Clearing the DTC
DTC P2428 is a Type A DTC.
Diagnostic Aids
• |
After starting the engine, the
exhaust gas temperature sensor temperature should rise steadily,
then stabilize after the engine reaches operating
temperature. |
• |
If the vehicle has set
overnight, the exhaust gas temperature sensor and the intake air
temperature (IAT) sensor values should display within 3°C
(5°F). |
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
1. |
Engine running, observe the
DTC information with a scan tool. DTCs P2032, P2033 or P2428 should
not set. |
2. |
Operate the vehicle within the
Conditions for Running the DTC to verify the DTC does not reset.
You may also operate the vehicle within the conditions that you
observed from the Freeze Frame/Failure Records data. |
Circuit/System Testing
1. |
Ignition OFF, disconnect the
harness connector at the B131 Exhaust Temperature Sensor.
|
2. |
Test for less than 5 Ω
between the low reference circuit terminal 2 and ground.
|
⇒ |
If greater than the specified range, test the low
reference circuit for an open/high resistance. If the circuit tests
normal, replace the K20 Engine Control Module. |
3. |
Disconnect the harness
connector at the cooling fan. |
4. |
Ignition ON, verify the scan
tool Exhaust Gas Temperature Sensor 1 parameter is at 5 V.
|
⇒ |
If less than the specified range, test the signal
circuit for a short to ground. If the circuit tests normal, replace
the K20 Engine Control Module. |
|
Note: If the fuse in
the jumper wire opens, the signal circuit is shorted to a voltage
and the sensor may be damaged.
|
5. |
Install a 1 A fused jumper
wire between the signal circuit terminal 1 and ground. Verify the
scan tool Exhaust Gas Temperature Sensor 1 parameter is at 0
V. |
⇒ |
If greater than the specified range, test the
signal circuit for a short to voltage or an open/high resistance.
If the circuit tests normal, replace the K20 Engine Control
Module. |
6. |
If all circuits test normal,
test or replace the B131 Exhaust Temperature Sensor. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
|