DTC P0658 or P0659
Diagnostic Instructions
DTC Descriptors
DTC P0658 00: Actuator High Control Circuit
Group 1 Low Voltage |
DTC P0659 00: Actuator High Control Circuit
Group 1 High Voltage |
Circuit/System Description
These DTC apply to internal 5 V reference voltage supply within
the engine control module (ECM).
Conditions for Running the DTC
• |
The DTCs run continuously once
the above condition is met. |
Conditions for Setting the DTC
P0658
The internal 5 V reference voltage is to low.
P0658
The internal 5 V reference voltage is to high.
Action Taken When the DTC Sets
DTC P0658 and P0659 are Type C DTCs.
Conditions for Clearing the DTC
DTC P0658 and P0659 are Type C DTCs.
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
1. |
Observe the Freeze
Frame/Failure Records with a scan tool. |
2. |
Clear the DTCs with a scan
tool. |
3. |
Ignition OFF for 30 s.
|
4. |
Operate the vehicle within the
Conditions for Running the DTC. You may also operate the vehicle
within the conditions that you observed from the Freeze
Frame/Failure Records. |
⇒ |
If DTC P0658 or P0659 is reset this ignition,
replace the K20 Engine Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for ECM replacement, setup, and
programming
|