Evaporative Emission Canister Replacement
Removal Procedure
|
Warning:
Do not breathe the air through the EVAP component
tubes or hoses. The fuel vapors inside the EVAP components may
cause personal injury. |
|
Note: Do not remove
the fuel tank filler hose when the fuel tank is over half filled
with fuel.
|
| 3. |
Remove the fuel tank filler
hose (3) from the fuel tank filler pipe (1) |
|
Warning:
To help avoid personal injury, always use jack
stands when you are working on or under any vehicle that is
supported only by a jack. |
|
Caution: When you are jacking or lifting a vehicle at the frame
side rails or other prescribed lift points, be certain that the
lift pads do not contact the catalytic converter, the brake pipes
or the fuel lines. If such contact occurs, vehicle damage or
unsatisfactory vehicle performance may result. |
| 4. |
Place a suitable adjustable
jack under the fuel tank. |
| 5. |
Remove the 2 fuel tank strap
bolts (2). |
| 6. |
Remove the 2 fuel tank straps
(1). |
|
Note: Closely watch
parts like pipes or hoses that are still installed to the fuel
tank. If lowering the fuel tank slightly does not provide enough
access to remove the fuel tank, refer to
Fuel Tank Replacement .
|
| 7. |
Lower the fuel tank to a
height where the evaporative emission canister is easily
accessible. |
|
Warning:
Always wear safety goggles when working with fuel
in order to protect the eyes from fuel splash. |
| 8. |
Disconnect the fuel tank vent
pipe (2). |
| 9. |
Disconnect the evaporative
emission canister wiring harness plug. |
| 10. |
Disconnect the evaporative
emission canister purge pipe (4). |
| 11. |
Remove the evaporative
emission canister (1) from the evaporative emission canister
bracket (3). |
Installation Procedure
| 1. |
Install the evaporative
emission canister (1) to the evaporative emission canister bracket
(3). |
| 2. |
Connect the evaporative
emission canister purge pipe (4). |
| 3. |
Connect the evaporative
emission canister wiring harness plug. |
| 4. |
Connect the fuel tank vent
pipe (2). |
| 5. |
Raise the fuel tank to its
original position. |
| 6. |
Install the 2 fuel tank straps
(1). |
| 7. |
Install the 2 fuel tank strap
bolts (2) and tighten to 23 N·m (17 lb ft)
. |
| 8. |
Remove the adjustable
jack. |
| 9. |
Install the fuel tank filler
hose (3) to the fuel tank filler pipe (1). |
| 10. |
Install the clamp (2) and
tighten to 3 N·m (27 lb in) . |
|
