vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
DTC P0641 or P06A6 > < DTC P025A

Astra J

DTC P0601-P0604, P0606, or P062F - Fuel Pump Control Module

Diagnostic Instructions

    •  Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    •  Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC P0601:  Control Module Read Only Memory (ROM)

DTC P0602:  Control Module Not Programmed

DTC P0603:  Control Module Long Term Memory Reset

DTC P0604:  Control Module Random Access Memory (RAM)

DTC P0606:  Control Module Internal Performance

DTC P062F:  Control Module Long Term Memory Performance

Circuit/System Description

The internal fault detection is handled inside the fuel pump control module. No external circuits are involved.

Conditions for Running the DTC

The fuel pump control module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This program runs even if the voltage is out of the valid operating range.

Conditions for Setting the DTC

The fuel pump control module has detected an internal malfunction.

Action Taken When the DTC Sets

DTC P0601, P0602, P0603, P0604, P0606 and P062F are type A DTCs.

Conditions for Clearing the DTC

DTC P0601, P0602, P0603, P0604, P0606 and P062F are type A DTCs.

Reference Information

Description and Operation

Fuel System Description

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Wiring Repairs


DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification

Note:  This DTC may be stored as a history DTC without affecting the operation of the module. If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.

  1. Verify that DTC P0602 is not set.
    2. ⇒ If the DTC is set, program the K27 fuel pump control module.
  2. Verify that DTCs P0601, P0603, P0604, P0606, and P062F are not set.
    3. ⇒ If any of the DTCs are set, program the K27 fuel pump control module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for fuel pump control module replacement, set-up, and programming

DTC P0641 or P06A6 > < DTC P025A