DTC P0610 - LDE
Diagnostic Instructions
DTC Descriptor
DTC P0610 00: Control Module Vehicle Options
Incorrect
Circuit/System Description
This diagnostic verifies that the engine control
module (ECM) is programmed for the correct vehicle
options.
Conditions for Running the DTC
• |
The ignition voltage is between 8-16 V. |
Conditions for Setting the DTC
The ECM detects that programming for vehicle options is
incorrect.
Action Taken When the DTC Sets
• |
DTC P0610 00 is a Type C DTC. |
• |
The service vehicle soon indicator will
illuminate. |
Conditions for Clearing the DTC
DTC P0610 00 is a Type C DTC.
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References
Circuit/System Verification
- Engine running, observe the DTC information with a
scan tool. DTC P0610 00 should not set.
- Operate the vehicle within the conditions for running
the DTC to verify the DTC does not reset. You may also operate the
vehicle within the conditions that you observed from the freeze
frame/failure records data.
Circuit/System Testing
- Program the K20 Engine Control Module. Refer to
Control Module References
- Clear DTCs with a scan tool.
- Ignition OFF, allow the K20 Engine Control Module
to completely power down.
- Operate the vehicle within the conditions for running
DTC P0610 00.
- Verify with a scan tool that DTC P0610 00
has not reset.
⇒ |
If DTC P0610 00 does reset, replace the
K20 Engine Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for ECM replacement, setup, and
programming
|