Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
| 1. |
Remove the engine wiring
harness guide (1) from the cylinder head. |
| 2. |
Disconnect the ignition coil
plug (2). |
|
Note: Note the arrow
on the cover.
|
| 3. |
Remove the cover of the
ignition coil in the direction of the arrow. |
| 4. |
Remove the 2 ignition coil
bolts. |
| 5. |
Install the EN-6009
remover/installer (1). |
| 6. |
Remove the ignition coil
(2). |
| 7. |
Remove the EN-6009
remover/installer (1). |
Installation Procedure
| 1. |
Install the EN-6009
remover/installer (1). |
| 2. |
Remove the ignition coil
(2). |
| 3. |
Remove the EN-6009
remover/installer (1). |
| 4. |
Install the 2 ignition coil
bolts an tighten to 8 N·m (71 lb in)
. |
|
Note: Note the arrow
on the cover.
|
| 5. |
Install the ignition coil
cover in the direction of the arrow. |
| 6. |
Connect the ignition coil plug
(2). |
| 7. |
Install the engine wiring
harness guide (1) at the cylinder head. |
|
