Knock Sensor Replacement (LDE, LXV, LUW, 2H0 and LFH)
Removal Procedure
3. |
Remove the 2 intake manifold
bracket bolts (2, 3). |
4. |
Unclip the wiring
harness. |
5. |
Remove the intake manifold
bracket (1). |
6. |
Remove the sensor bolt
(1). |
7. |
Disconnect the wiring harness
plug. |
8. |
Remove the knock sensor (2)
from the bracket (3). |
Installation Procedure
1. |
Install the knock sensor (2)
to the bracket (3). |
2. |
Install the sensor bolt (1)
and tighten to 20 N·m (15 lb ft) .
|
3. |
Connect the wiring harness
plug. |
4. |
Install the intake manifold
bracket (1). |
5. |
Clip in the wiring
harness. |
6. |
Install the 2 intake manifold
bracket bolts (2, 3) and tighten to 8 N·m (71 lb
in) . |
|