DTC P0611 (LPL or LPV)
Diagnostic Instructions
DTC Descriptor
DTC P0611 09: Control Module Performance |
DTC P0611 0A: Control Module Performance |
Circuit/System Description
These DTCs apply to internal microprocessor integrity conditions
within the engine control module (ECM). This diagnostic also
addresses if the ECM is not programmed.
Conditions for Running the DTC
• |
The DTCs run continuously once
the above condition is met. |
Conditions for Setting the DTC
The ECM detects an internal condition for greater than 1 s.
Action Taken When the DTC Sets
DTC P0611 is a Type A DTC.
Conditions for Clearing the DTC
DTC P0611 is a Type A DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Testing
1. |
Observe the Freeze
Frame/Failure Records with a scan tool. |
2. |
Clear the DTCs with a scan
tool. |
3. |
Ignition OFF for 30 s.
|
4. |
Operate the vehicle within the
Conditions for Running the DTC. You may also operate the vehicle
within the conditions that you observed from the Freeze
Frame/Failure Records. |
⇒ |
If DTC P0611 failed this ignition, replace the K20
Engine Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References for ECM replacement, setup, and
programming
|