Astra J
Mass Airflow Sensor ReplacementRemoval Procedure
|
1. | Open the hood. |
2. | Disconnect the wiring harness plug (2). |
3. | Loosen the 2 clamps (3). |
4. | Remove the mass airflow sensor (1). |
Installation Procedure
1. | Install the mass airflow sensor (1). |
Caution: Refer to Fastener Caution . |
2. | Fasten the 2 clamps (3) to 3.5 N·m (31 lb in) . |
3. | Connect the wiring harness plug (2). |
4. | After replacement of mass air flow sensor, use a scan tool to perform the appropriate learn function. Refer to Engine Control Module Programming and Setup . |
5. | Close the hood. |