DTC P160D
Diagnostic Instructions
DTC Descriptor
DTC P160D 00: Incorrect Engine Calibration
Detected
Circuit/System Description
This diagnostic addresses if the ECM is not programmed with the
right engine calibration.
Conditions for Running the DTC
• |
The DTC runs continuously once the above condition
is met. |
Conditions for Setting the DTC
The ECM detects that a wrong engine calibration is programmed in
the EEPROM for greater than 1 second.
Action Taken When the DTC Sets
DTC P160D is a Type A DTC.
Conditions for Clearing the DTC
DTC P160D is a Type A DTC.
Reference Information
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Circuit/System Testing
Program the ECM. If DTC P160D sets after programming,
perform the following steps:
• |
Ensure that all tool connections are secure. |
• |
Ensure the programming equipment is operating
correctly. |
• |
Ensure the correct software and the correct
calibration is used. |
• |
Attempt to program the K20 Engine Control
Module. |
⇒ |
If DTC P160D sets, replace the
K20 Engine Control Module. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic
procedure.
Control Module References
|