DTC P2458
Diagnostic Instructions
DTC Descriptor
DTC P2458 51: Diesel Particulate Filter
(DPF) Regeneration Time
DTC P2458 56: Diesel Particulate Filter
(DPF) Regeneration Time
DTC P2458 57: Diesel Particulate Filter
(DPF) Regeneration Time
Circuit/System Description
The soot particles accumulate in the channels of the DPF and are
burned off at regular intervals, through a process called
regeneration or cleaning. The DPF cleaning process prevents the DPF
from clogging. Excess soot in filter can cause a drop in engine
performance and crack the filter during regeneration.
Conditions for Running the DTC
• |
The engine coolant temperature (ECT) is between
73-96°C (163-205°F). |
Conditions for Setting the DTC
• |
The ECM detect to long regeneration times |
• |
The above condition is met. |
Action Taken When the DTC Sets
DTC P2458 is a Type C DTC.
Conditions for Clearing the DTC
DTC P2458 is a Type C DTC.
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References
Circuit/System Verification
- The following conditions must be met for the ECM to
perform the turbocharger learn procedure:
• |
The vehicle is in Park or Neutral. |
• |
Start and idle the engine. |
• |
The engine coolant temperature (ECT) is greater
than 40°C (104°F). |
- Perform the DPF Service Regeneration.
- Verify the DTC does not reset.
If the DTC resets, replace the DPF filter.
|