Auxiliary Water Pump Bracket Replacement - 2.0L Diesel LBS
Removal Procedure
- Remove the engine control module. Refer to
Engine Control Module Replacement .
- Remove the battery tray. Refer to
Battery Tray Replacement .
- Remove the auxiliary water pump bracket
bolt (1).
- Drain the cooling system. Refer to
Cooling System Draining and Filling .
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle .
- If equipped remove the engine shield. Refer to
Engine Shield Replacement .
- If equipped remove the front compartment splash
shield. Refer to
Front Compartment Splash Shield Replacement .
- If equipped remove the front compartment insulator.
Refer to
Front Compartment Insulator Replacement .
- Remove the auxiliary water pump outlet hose
clamp (4) and the auxiliary water pump outlet
hose (3).
- Disconnect the auxiliary water pump wiring harness
plug (2) from the auxiliary water pump (5).
- Remove the heater outlet hose clamp (6) and the
heater outlet hose (1).
- Remove the starter ground cable nut (2).
- Remove the starter ground cable (1) from the
starter (3) and hang it aside.
- Remove the starter stud (3).
- Remove the auxiliary water pump bracket along with the
auxiliary water pump (1).
- Remove the 3 auxiliary water pump
bolts (1).
- Remove the auxiliary water pump (3) from the
auxiliary water pump bracket (2).
Installation Procedure
Caution: Refer to
Fastener Caution in the Preface
section.
- Install the auxiliary water pump (3) to the
auxiliary water pump bracket (2).
- Install and tighten the 3 auxiliary water pump
bolts (1).
- Install the auxiliary water pump bracket along with
the auxiliary water pump (1).
- Loosely install the auxiliary water pump bracket
bolt (2).
- Install the starter stud (3) and tighten to
22 N·m (16 lb ft)
.
- Install the starter ground cable (1) to the
starter (3).
- Install the starter ground cable nut (2) and
tighten to
17 N·m (13 lb ft)
.
- Install the heater outlet hose (1) with the
heater outlet hose clamp (6).
- Connect the auxiliary water pump wiring harness
plug (2) to the auxiliary water pump (5).
- Install the auxiliary water pump outlet hose (3)
with the auxiliary water pump outlet hose clamp (4).
- If equipped install the front compartment insulator.
Refer to
Front Compartment Insulator Replacement .
- If equipped install the front compartment splash
shield. Refer to
Front Compartment Splash Shield Replacement .
- If equipped install the engine shield. Refer to
Engine Shield Replacement .
- Lower the vehicle.
- Tighten the auxiliary water pump bracket bolt (1)
to 23 N·m (17 lb ft)
.
- Install the battery tray. Refer to
Battery Tray Replacement .
- Install the engine control module. Refer to
Engine Control Module Replacement .
- Fill the cooling system. Refer to
Cooling System Draining and Filling .
|