Alternator and Starter Cable Replacement - LBQ, LBR, LBS, LBX
without Start/Stop
Removal Procedure
- Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection .
- Unlock the retaining tab (1) on the battery fuse
box cover.
- Use a suitable screwdriver (2) to unlock the
clip (4) through the window (3).
Note: Pull the battery fuse box
housing. DO NOT pull the flap.
- Open the battery fuse box cover (1).
- Remove the battery positive cable to starter
nut (2).
- Remove the battery positive cable to starter (3)
from the battery.
- Remove the battery ground cable nut (1).
- Remove the negative cable (2).
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle .
- Open the front compartment service opening.
- Unclip the alternator and starter cable
conduit (1) from the bracket (2).
- Open the 2 wiring harness clips (1) and
remove the wiring harness (2) from the clips.
- Remove the starter ground cable nut (4) and
remove the negative cable (1).
- Remove the starter and alternator positive cable
nut (3) and remove the starter and alternator positive
cable (2).
- Disconnect the wiring harness plug (1) from the
alternator (2).
- Remove the alternator positive cable nut (4) and
remove the alternator positive cable (3) from the
alternator.
- Lower the vehicle.
- Remove the alternator and starter cable.
Installation Procedure
- Install and reposition the alternator and starter
cable.
- Clip the alternator and starter cable conduit (1)
into the bracket (2).
- Raise the vehicle.
- Connect the wiring harness plug (1) to the
alternator (2).
- Install the alternator positive cable (3) to the
alternator.
Caution: Refer to
Fastener Caution in the Preface
section.
- Install the positive cable nut (4) and tighten
to 13 N·m (115 lb in)
.
- Install the starter ground cable (1) to the
starter (5).
- Install the starter ground cable nut (4) and
tighten to 17 N·m
(13 lb ft) .
- Install the starter positive cable (2) and
tighten the starter positive cable nut (3) to
13 N·m (115 lb in) .
- Close the front compartment insulator service
opening.
- Reposition the wiring harness (2).
- Close the 2 wiring harness clips (1).
- Install the battery negative cable (2).
- Install the battery ground cable nut (1) and
tighten to 9 N·m
(80 lb in) .
- Install the battery positive cable (3) to the
battery.
- Install the battery positive cable nut (2) and
tighten to 12 N·m
(106 lb in) .
- Close the battery fuse box cover and lock the
retaining tabs (1) and (4).
- Connect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection .
|