Battery Negative Cable Disconnection and Connection - without
Start/Stop System
Removal Procedure
- Turn on the radio and record all of the customer radio
station presets.
- Ensure that all lamps and accessories are turned
off.
- Turn the ignition OFF and remove the ignition
key.
- Remove the battery cover (1).
Warning: Refer to
Battery Disconnect Warning in the
Preface section.
- Loosen the battery negative cable nut (2).
- Remove the battery negative cable (1) from the
battery.
Installation Procedure
- Install the battery negative cable (1) to the
battery.
Caution: Refer to
Fastener Caution in the Preface
section.
- Fasten the battery negative cable nut (2) and
tighten the nut to 4.5 N·m
(40 lb in) .
- Install the battery cover (1).
- Insert the ignition key and turn the ignition to the
ON position.
- Program volatile memory. Refer to
Volatile Memory Programming .
- Program all of the customer's radio station presets
and set the radio clock to the current time.
|