Piston and Connecting Rod Disassemble (1.4L LUH, LUJ and
LUV)
Special Tool
EN-49941 Remover / Installer Piston Retainer Ring
For equivalent regional tools, refer to
Special Tools .
|
Warning:
Handle the piston carefully. Worn piston rings
are sharp and may cause bodily injury. |
1. |
Remove the piston rings. Use
piston ring pliers (1) |
2. |
The piston rings are ordered
as followed: |
|
• |
Upper compression ring
(1) |
|
• |
Lower compression ring
(2) |
|
• |
Oil rings and oil ring spacer
(3) and (4) |
3. |
Install the piston and
connecting rod assembly to a bench vise. Use aluminium
braces |
|
Warning:
Use extreme care when removing snap rings. Always
wear adequate eye protection in order to avoid personal
injury. |
4. |
Apply the EN-49941
remover (1) in the notch (3) to the piston pin retainer (2)
and remove it. |
5. |
Remove the piston pin (2) and
the connecting rod (3) from the piston (1). |
|