Engine Front Cover and Oil Pump Disassemble
Engine Front Cover Disassemble
| 1. |
Remove the intake camshaft
position sensor bolt (1). |
| 2. |
Remove the intake camshaft
position sensor (2) and the seal ring (3). |
| 3. |
Remove the exhaust camshaft
position sensor bolt (6). |
| 4. |
Remove the exhaust camshaft
position sensor (5) and the seal ring (4). |
| 5. |
Remove the oil pressure relief
valve (7, 8 and 9) |
| 6. |
Remove the crankshaft front
oil seal (10). |
Oil Pump Removal
| 1. |
Remove the 8 oil pump cover
bolts (1). |
| 2. |
Remove the oil pump cover
(2). |
|
Warning:
Before removing the spring, cover the spring with
a towel to prevent the spring from flying and possibly causing
damage or personal injury. |
|
Note: Position a
screw driver between the oil pump slide spring windings (2).
|
| 3. |
Protect the engine front cover
edge (1) with a suitable piece of plastic. |
| 4. |
Compress the oil pump slide
spring with a screw driver and remove the oil pump slide spring
along with the oil pump slide spring pin. |
|
Note: Mind the
installation position of the oil pump components.
|
| 5. |
Remove the oil pump components
in the following order: |
| |
5.1 |
Outer oil pump vane ring
(1). |
| |
5.2 |
Oil pump vane rotor (3) and
the 7 oil pump vanes (2). |
| |
5.3 |
Inner oil pump vane ring
(6). |
| |
5.4 |
Oil pump slide (4) and the 2
oil pump slide seals with the 2 oil pump slide seal springs
(5). |
|
