Power Steering Pump Belt Replacement
Special Tools
EN-50098 Belt Installer
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
|
Caution: Do
not use belt dressing on the drive belt. Belt dressing causes the
breakdown of the composition of the drive belt. Failure to follow
this recommendation will damage the drive belt. |
| 2. |
Cut the power steering pump
belt (2) with a appropriate cutting tool at position (1).
|
| 3. |
Remove the power steering pump
belt (2). |
Installation Procedure
| 1. |
Install EN-50098
installer (2) and a NEW power steering pump belt (1) to
water pump pulley and power steering pump pulley. |
| 2. |
Turn the engine slowly
clockwise at the crankshaft balancer bolt. |
| 3. |
During turn the engine take
care of the proper installation of the power steering pump belt to
the water pump pulley (3). |
| 4. |
Remove the EN-50098
installer (2). |
| 5. |
Check the power steering pump
belt is installed clearly. |
|
