Camshaft Sprocket Installation
Special Tools
• |
EN-45059
Torque Angle Sensor Kit |
For equivalent tools, refer to
Special Tools .
1. |
Install the camshaft sprockets
(3) |
|
Note: Turn the
sprockets around till them locked in correct position.
|
2. |
Install the camshaft sprocket
washers (2) and NEW camshaft sprocket bolts (1) and
handtighten. |
|
Note: A second
technician is required.
|
3. |
Install EN-6347
holding tool (1) and EN-956-1 extension (2)
into the camshaft sprocket. |
4. |
Loosen the locking bolts (3)
from the EN-6347 holding tool . |
5. |
Tighten the bolt (4) :
|
|
5.1 |
First pass tighten to
50 N·m (37 lb ft) . |
|
5.2 |
Second pass to 60°
+ 15° using the EN-45059 sensor kit
. |
|
5.3 |
Remove EN-6347
holding tool and EN-956-1 extension . |
|