Fuel Injection Pump Driven Sprocket Installation (LBQ, LBR,
LBS, LBX, and LCD)
Special Tools
For equivalent regional tools, refer to
Special Tools .
1. |
Install the fuel injection
pump driven sprocket (2) in the correct position (1). |
2. |
Install the fuel injection
pump driven sprocket nut (3). |
3. |
Install the EN-6347
holder (1) with the EN-956-1 extension (2)
to the fuel injection pump driven sprocket. |
4. |
Tighten the fuel injection
pump driven sprocket nut to 50 N·m (37 lb
ft) . |
5. |
Remove the EN-6347
holder with the EN-956-1 extension from the
fuel injection pump driven sprocket . |
|