Engine Oil and Oil Filter Replacement
Special Tools
EN-49377 Retainer
For equivalent regional tools, refer to
Special Tools .
Removal Procedure
2. |
Open the front compartment
insulator service opening. |
4. |
Place a drain pan under the
oil drain screw. |
5. |
Remove the oil drain screw (2)
and the seal ring (1). |
6. |
DISCARD the seal ring
(1) |
7. |
Allow the oil to drain
completely. |
8. |
Install the oil pan drain
screw along with a NEW seal ring and tighten to 20
N·m (15 lb ft) . |
9. |
Install the EN-49377
retainer (2) below the engine oil filter housing (1) and oil
filter cap. |
10. |
Place a suitable container
below the EN-49377 retainer (2). |
|
Note: Do NOT use an
open end wrench on the hex on top of the oil filter cap.
|
11. |
Remove the oil filter cap (2)
along with the oil filter element (1) and the oil filter cap seal
ring. |
12. |
Unclip the oil filter element
(1) from the oil filter cap (2). |
13. |
DISCARD the oil filter cap
seal ring. |
Installation Procedure
1. |
Install a NEW oil filter cap
seal ring (1) to the shown groove (arrow). |
2. |
Lubricate the oil filter cap
threads (2) and the oil filter cap seal ring with clean engine
oil. |
3. |
Clip the NEW oil filter
element (1) to the oil filter cap (2). |
|
Note: DO NOT use an
open end wrench on the hex on top of the oil filter cap.
|
4. |
Install the oil filter cap (2)
along with the oil filter element and the NEW oil filter cap seal
ring and tighten to 25 N·m (18 lb ft)
. |
5. |
Remove the EN-49377
retainer (2) from the engine oil filter housing (1).
|
6. |
Close the front compartment
insulator service opening. |
|