Astra J
Relay Replacement (Within an Electrical Center)Special ToolsEL-43244 Relay Puller PliersRemoval Procedure
|
1. | Remove the electrical center cover. |
2. | Locate the relay. Refer to Electrical Center Identification Views to locate the electrical center where the relay exists. |
Note:
|
3. | Using the EL-43244 (1) position the tool on opposing corners of the relay (2). |
Caution: Use EL-43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center. |
4. | Remove the relay (2) from the electrical center. |
Installation Procedure
1. | Install the relay (2) in the same position as removed. |
2. | Install the electrical center cover. |