Clutch Pedal Position Sensor Learn
Note: The clutch pedal
position (CPP) sensor learn procedure is required when the
following service procedures have been performed:
| • |
An engine control
module (ECM) replacement |
| • |
A CPP sensor
replacement |
| • |
Any repairs which
affect the CPP sensor relationship |
| 3. |
With a scan tool, select
Clutch Pedal Position Learn under Module Setup in Manual
Transmission, and perform the following instructions displayed on
the scan tool screen. |
|
Note: The CPP sensor
learn procedure cannot be performed more than once per ignition
cycle. The clutch pedal needs to be fully depressed and held steady
throughout this procedure in order to perform a correct
learning.
|
| 4. |
The scan tool will display
under CPP Learn Status: Not Learned, In Process, Complete, Fail -
Low Volt, Fail - High Volt, or Fail Moving. The scan tool will
display under CPP Learn Status Complete if the process was
successful. |
| 6. |
Turn OFF the ignition for 30 s
after the learn procedure has successfully completed in order to
store the CPP sensor variation values in ECM history. |
|
