Window Winder – Rear Door, Remove and
Install – Electrical/Manual Actuation (Model F 68)
Remove
1. |
Remove rear door inner panelling
• |
Pull off water vapour barrier
|
|
3. |
Drill off window winder rivets (arrows)
• |
Remove window winder
Note: Figure shows the
removal of manual window winder
|
|
|
|
Install
4. |
Knock remains of rivet heads out of window winder
|
5. |
Coat sliding piece with special grease
|
6. |
Rivet rear window winder firmly in position with steel blind
rivets, diameter 4.8 x 11 mm
|
8. |
Attach water vapour barrier
Note: Replace damaged
water vapour barrier
|
9. |
Install rear door inner panelling
|
|