|
Remove and install or replace moulded headlining -
folding sunroof (Model F 68)
 Remove
| 1. |
Remove load compartment cover 
|
| 2. |
Remove C-pillar inner panelling
|
| 3. |
Release front seat belt at guide fitting
|
| 4. |
Remove upper inner panelling of B-pillar (model F68)
|
| 5. |
Remove inner panelling for upper A-pillar
|
| 6. |
Release front door weatherstrip in the area of the moulded
headlining (model F68)
|
| 7. |
Remove rear interior light (Model F 68)
|
| 8. |
Remove interior light panel
|
|
| 10. |
Remove interior light (2)
|
| 11. |
Remove handle in moulded headlining (3)
|
| 12. |
Remove storage compartment for spectacles (I)
Note: Only for vehicles
with storage compartment for spectacles.
|
| 13. |
Release moulded headlining at the rear
| • |
Unclip 3 plugs (4)
Note: Push off plugs on
moulded headlining with plug remover KM-569-A .
|
| • |
Disconnect wiring harness plug for folding sun roof servo
motor
|
|
|
| 14. |
Remove moulded headlining to the rear through open tailgate
Note: 2nd mechanic
required.
|
Install
| 15. |
Insert moulded headlining through open tailgate and align
Note: 2nd mechanic
required.
|
| 16. |
Fasten moulded headlining at the rear
| • |
Connect wiring harness plug for folding sun roof servo
motor
|
|
| 17. |
Install storage compartment for spectacles
Note: Only for vehicles
with storage compartment for spectacles.
|
| 18. |
Install handle in moulded headlining
|
| 19. |
Remove interior light panel
|
| 20. |
Remove rear interior light (Model F 68)
|
| 22. |
Fasten front door weatherstrip in the area of the moulded
headlining (model F68)
|
| 23. |
Install upper A-pillar inner panelling
|
| 24. |
Install upper B-pillar inner panelling (model F68)
|
| 25. |
Install guide fitting for front seat belt at height adjuster
|
| 26. |
Fit C-pillar inner panelling
|
| 27. |
Install rear seat belt guide fitting on C-pillar (model F68)
|
| 28. |
Install load compartment cover
|
| 29. |
Check correct seating of front door and tailgate sealing
lips.
|
|
