Sliding Block Assembly, Remove and Install
Note: The slide
assembly is supplied by the Aftersales department as an assembly.
The guides of the slide assembly are not replaced individually in
service with the exception of the water gutter guide.
Remove
1. |
The actuation unit and actuation cable must be checked for
damage after removing the sliding block assembly - replace
actuation cable.
|
|
2. |
Overview of the guides in the slide assembly:
I
|
Front guide
|
II
|
Side guide
|
III
|
Rear guide
|
IV
|
Water gutter guide
|
|
|
5. |
Remove crank drive
• |
For sliding sunroof with electric drive
|
|
|
6. |
Push connecting pin (1) of the rear guide backwards as far as
the stop until engaging lever (2) of the front guide
disengages.
|
7. |
Push the sliding block assembly further backwards until the
water gutter guide (5) and the rear guide (4) project from the
actuation unit.
|
8. |
Unclip actuating cable (3) from the rear guide (4) and pull the
complete sliding block assembly out of the actuation unit.
|
|
Install
|
9. |
Press engaging lever of the front guide (1) and push the front
guide (2) into the actuation unit, clip actuating cable of the rear
guide to the rear guide and push the rear guide into the actuating
unit, water gutter guide.
Note: Push the slide
assembly (3) completely forwards (engaging lever of front guide
must engage in the recess (4) of the guide rail).
|
|
10. |
Adjust both actuation cables
|
11. |
Install crank drive
• |
For sliding sunroof with electric drive
|
• |
Adjust crank drive
– |
For vehicles with electric drive
|
|
|
13. |
Install actuation unit
|
|