Wheel Brake Cylinder, Remove and Install
Note: Repair or
overhaul of wheel brake cylinder is not envisaged for the time
being.
Remove
1. |
Detach seal (1) for plenum chamber as far as necessary.
• |
Remove closure cap (3) of brake fluid reservoir and seal with
MKM-558-10
|
|
2. |
Detach rear wheel
• |
Mark position in respect of drum hub/brake drum
|
|
4. |
Unscrew brake line (4)
• |
Collect escaping brake fluid and close outlets
|
• |
Detach fastening bolt (5) and remove wheel brake cylinder
|
|
|
|
5. |
Check brake shoes
Note: Brake shoes
contaminated with brake fluid must be replaced
|
6. |
Clean brake anchor plate and drum hub/brake drum.
|
Install
7. |
Attach wheel brake cylinder with fastening bolt (2) to brake
anchor plate - tightening torque 9
Nm
|
8. |
Attach brake line (1) to wheel brake cylinder - tightening
torque 16 Nm .
|
10. |
Remove MKM-558-10 (3) from brake
fluid reservoir
|
|
|
11. |
Bleed brake system and check for leaks
|
12. |
Correct brake fluid level up to mark "MAX".
|
13. |
Fit rear wheel - tightening torque 110
Nm
|
14. |
Close closure cap (2)
• |
Place seal (1) on plenum chamber
|
|
|
|
|