|
Brake Fluid Reservoir, Remove and Install (LHD
Vehicles)
 Remove
| 1. |
Pull seal (1) away from plenum chamber as far as necessary
| • |
Raise covering flap (2) for brake master cylinder
|
| • |
Detach closure cap (3) from brake fluid reservoir
|
|
| 2. |
Evacuate brake fluid from brake fluid reservoir as far as
possible with a siphon bottle (available commercially)
|
| 3. |
Unlatch and disconnect wiring harness plug (4) for brake fluid
sensor on brake fluid reservoir
| • |
Detach supply hose (5) for brake fluid on clutch master
cylinder from brake fluid reservoir
|
|
| 4. |
Release fastening clamps (arrow) of brake fluid reservoir on
brake master cylinder on both sides with screwdriver
| • |
Remove brake fluid reservoir from brake master cylinder upwards
(6)
|
|
|
|
| 5. |
Remove seal rings of brake fluid reservoir with a suitable tool
from the brake master cylinder
|
| 6. |
Clean sealing surfaces on brake master cylinder
|
Install
| 7. |
Insert new seal rings (1) in brake master cylinder
| • |
Attach brake fluid reservoir (2) to brake master cylinder
Note: Ensure correct
seating of the retaining clips (arrow) on both sides
|
|
| 8. |
Connect wiring harness plug (4) for brake fluid sensor
| • |
Connect supply hose (5) for brake fluid to clutch master
cylinder on brake fluid reservoir
|
|
| 9. |
Correct brake fluid reservoir so that it reaches the "MAX"
mark
|
| 10. |
Bleed brake system and check for leaks 
|
|
|
| 11. |
Install closure cap (1) on brake fluid reservoir
|
| 12. |
Close covering flap (3) for brake master cylinder
| • |
Place seal (2) on plenum chamber
|
|
|
|
|
