Replace rear crankshaft sealing ring (Y 17 DT,
without air conditioning, RHD)
1. |
Remove manual transmission
Note: See operation "K
2051 00 Removing and installing manual transmission" in group
"K".
|
2. |
Remove clutch
Note: See operation
"Removing and installing pressure plate and clutch disk (without
SAC)" in group "K".
|
4. |
Remove rear crankshaft sealing ring
Important: Do not damage sealing
surface.
|
• |
Lever out seal ring (1)
|
|
|
|
5. |
Clean sealing surfaces.
|
6. |
Fit rear crankshaft sealing ring
• |
Coat sealing lip with silicon grease (white)
|
• |
Attach KM-658-2 to crankshaft
journal
|
• |
Slide sealing ring onto KM-658-2
|
• |
Drive in until flush using KM-658-1
|
|
|
|
8. |
Insert centring sleeve
|
10. |
Attach flywheel
• |
Tighten bolts ( 29,4 Nm + 60° +
15° )
|
|
11. |
Install clutch
Note: See operation
"Removing and installing pressure plate and clutch disk (without
SAC)" in group "K".
|
12. |
Install manual transmission
Note: See operation "K
2051 00 Removing and installing manual transmission" in group
"K".
|
13. |
Check and correct engine oil level
• |
Observe specified engine oil quantity
|
|
|