|
Caution
Ensure that the lower valve spring caps are removed.
 Remove
Carefully drive out valve guide from upper side of cylinder head
using remover KM-6095-1 (1) from above downwards.
Install
Insert new valve guide from above. The chamfered side of the
valve guide points towards the cylinder head. Slide sleeve
KM-6095-2 (2) onto installer KM-6095-1 and carefully drive in valve
guide until stop from above downwards.
When driven in, check the valve guides for damage; ream valve
guide if necessary. See "Valve guide, ream".
|
