Vacuum pump - Z 13 DT DOHC diesel engine
Location of vacuum pump
|
The vacuum pump (1) is mounted on the cylinder head and is
driven by the inlet camshaft.
This supplies the vacuum to the brake servo.
|
|
Tightening sequence for the vacuum pump on the Z
13 DT engine
• Service:
To ensure operational reliability, the vacuum pump must be
tightened in the sequence shown when fitting it to the cylinder
head.
Tightening sequence
|
- Tighten fastening bolt (1) - tightening torque 5 Nm
- Tighten fastening bolt (2) - tightening torque 5 Nm
- Tighten fastening bolt (1) again - tightening torque 20 Nm
- Tighten fastening bolt (2) again - tightening torque 20 Nm
|
|
|