Replace engine damping block (left side) (Z 12 XE,
Z 12 XEP, Z 14 XEP, with air conditioning, LHD)
Note: KM-6394 must be used as of model year 04 instead of
KM-6169-1 .
Remove
3. |
Remove ribbed V-belt cover
|
|
|
4. |
Attach KM-6169-2 to transmission
|
|
|
5. |
Attach KM-6169 (1)
• |
Place left of KM-6169 onto front axle body (arrows, illus.
I)
– |
Guide pin must be seated in bore in front axle body
|
|
• |
Attach both right holders on the front axle body (arrows,
Illus. II).
– |
Guide pin must be seated in bore in front axle body (arrow,
Fig. III)
|
|
|
|
|
|
6. |
Fit support to KM-6169
• |
Adjust bracket (2) for support
|
|
7. |
Adjust supports
• |
Transmission side
– |
Turn spindles until mounts (3) are positioned at guide journals
free of play
|
|
• |
Engine timing side
– |
Insert journal of the support in the bore of the cylinder block
without play (arrow)
|
|
|
|
9. |
Remove left transmission bracket
• |
Loosen left engine damping block
|
|
10. |
Remove left engine damping block
|
|
|
11. |
Detach left engine damping block (1) from left engine damping
block adapter (2)
|
|
|
Install
12. |
Attach left engine damping block
• |
Tighten bolt 80 Nm + 45° +
15°
|
|
13. |
Install left engine damping block
|
14. |
Install transmission bracket
• |
To left engine damping block adapter
|
|
19. |
Install ribbed V-belt cover
|
|