vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
J607300 Replace ribbed V-belt tensioner (Z 14 XE, Z 16 YNG with air conditioning, LHD) > < Replace ribbed V-belt tensioner (Z 12 XE, Z 12 XEP, Z 14 XEP, with air conditioning, LHD)

Corsa C

J607000 Replace ribbed V-belt (Z 14 XE, Z 16 YNG with air conditioning, LHD)

1. Open bonnet

Important:   On vehicles as of model year 04 with ESP - the steering angle sensor loses its basic adjustment each time the battery is disconnected. It must be recalibrated.

2. Disconnect battery

  • Detach ground cable

3. Detach front right wheel

4. Raise vehicle

5. Remove front right wheel

  • Remove 4 bolts

6. Raise vehicle

7. Remove ribbed V-belt cover

  • Remove 3 bolts (1)
  • Remove clip (arrow).
 Object Number: 2410600 Size: DEFAULT

8. Remove ribbed V-belt

  • Tension ribbed V-belt tensioner in direction of arrow
    • With KM-913-A (2) (SW 15)
  • Insert KM-6130 (1)

9. Install ribbed V-belt

  • Note: Note running direction and installation position
  • Release ribbed V-belt tensioner
    • With KM-913-A
  • Remove KM-6130
 Object Number: 2410700 Size: DEFAULT

10. Install ribbed V-belt cover

  • Screw in bolts
  • Install clip

11. Lower vehicle

12. Install front right wheel

  • Screw in bolts

13. Lower vehicle

14. Attach front right wheel

  • Tighten bolts (110 Nm / 81 lbf. ft.)

15. Connect battery

16. Calibrate steering angle sensor

  • Switch on ignition

Note:   Rotate the steering wheel one time from its right-hand to its left-hand stop.

17. Program volatile memories

18. Close bonnet

J607300 Replace ribbed V-belt tensioner (Z 14 XE, Z 16 YNG with air conditioning, LHD) > < Replace ribbed V-belt tensioner (Z 12 XE, Z 12 XEP, Z 14 XEP, with air conditioning, LHD)