J313740 Front Toothed Belt Cover (Upper), Replace
(Z 14 XE, 16 with AC, LHD)
1. Open bonnet
2. Disconnect battery
Important: On
vehicles as of model year 04 with ESP - the steering angle sensor
loses its basic adjustment each time the battery is disconnected.
It must be recalibrated.
|
|
3. Remove air cleaner housing (1)
- Disconnect wiring harness plug
- Intake air temperature sensor (4), tank vent valve (2)
- Unclip tank vent valve
- Detach intake hose
- Detach engine vent hose (5)
- Remove bolt (3)
4. Remove toothed belt cover upper section
- Remove 3 bolts (arrows)
- Unclip from rear toothed belt cover
|
|
5. Install toothed belt cover upper section
- Clip to rear toothed belt cover
- Tighten bolts (4 Nm / 3 lbf. ft)
6. Install air cleaner housing
- Tighten bolt
- Install suction hose
- Attach engine vent hose
- Clip in tank vent valve
- Connect wiring harness plug.
7. Connect battery
8. Calibrate steering angle sensor
Note: Rotate the
steering wheel one time from its right-hand to its left-hand
stop.
9. Program volatile memories
10. Close bonnet
|